kondisi setting failsafe spt apa? mungkin failsafe dg setting throttle on (atau idle) pas gak ada sinyal? coba di-set dulu failsafe utk throttle minimum (nol) tanpa pirantai di atas, stl itu dicoba terpasang.
saya pernah lupa setting throttle minimum dan tx dimatikan. untung pesawat larinya gak jauh dan pelan2 saja krn di posisi 10-15% throttle, yg jelas bikin panik saja. pelajaran heboh yg tak terlupakan.
setelah itu failsafe jadi prosedur mutlak dilakukan, elevator full up, aileron/rudder netral, dan throttle nol supaya pas terjadi loss sinyal pesawat turun sendiri dg spt manuver '3d elevator'. Harapannya paling yg rusak hanya rodanya saja (minimal). Yg paling penting, tidak membahayakan orang lain di sekitarnya.
Mode III - Short lit followed by a long dark period, repeated 3 times
Mode III : enabling the failsafe 1. Turn on the transmitter with the antenna extended. 2. Turn on the receiver. The LED will blink 2 times. If the LED remains lit then the receiver is receiving correct commands from a transmitter. 3. Adjust the sticks and switches on the transmitter to the position that you feel will best protect your aircraft in the event of a loss of signal. Typically the throttle is decreased and a slight elevator input is required to maintain a controlled glide slope. You should notice as you set the sticks and switches that the receiver is responding indicating the transmitter and receiver are synchronized. 4. To set it up, press the scan button for 2 seconds, then release it. The LED blinks 3 times now (should it blink 2 times, then press the button again for 2 seconds). While in mode III, press the button shortly to start the failsafe enabling process. 5. The LED will flash 2 times and then remain lit. The transmitter now does not control the receiver and the failsafe has been enabled. You must now restart the receiver.
Caution: 1. Restart the receiver when the set up process of disabling or enabling the failsafe is completed.
silahkan ikuti petunjuk suhu Iwan21 dan sekedar tambahan dari pengalaman setting corona rx. Mungkin tidak akan langsung sekali berhasil, mungkin harus diulangi beberapa kali dan tes failsafe sudah ok atau belum. hati2 dan jauhkan prop yg muter dari jari ...
dulu pertama kali datang ke lapangan, selalu mematikan TX meskipun Batt belum dicabut. tapi terus mendapat teguran keras dari om Bing, bahwa sebelum mematikan TX pastikan Batt sudah dicabut. Meskipun sudah diset failsafe, dikhawatirkan ada rekan lain yang menyalakan TX dan secara tidak sengaja nyambung dengan Rx kita yang saat itu sudah mati Tx-nya, kan bahaya.
itulah pelajaran pertama saya dilapangan yg saya pake sampe sekarang.
